08-14-2021 02:09 AM
Hi All,
I am planning to set up a Homelab and want to configure multiple VLAN's in a single switch port, switch will connect to the Intel nuc PC (ESXi installed). Can I use "Cisco SG250-08 Smart Switch" to achieve this?
in the switch feature it says L2+/L3.. but not sure if it supports it.
Thanks in advance.
regards
prateek
Solved! Go to Solution.
08-14-2021 01:12 PM
yes you can use trunk configuration it should be ok.
08-14-2021 01:12 PM
yes you can use trunk configuration it should be ok.
08-23-2021 10:38 PM
Thanks, @balaji.bandi , configured the trunk, and it's working as expected.
I could see Switch port mode to Layer 3, what is the use case of this ?
08-30-2021 02:06 PM
I could see Switch port mode to Layer 3, what is the use case of this ?
you can make the interface as a Layer 3 port-channel with a subinterface if you like to use a Layer 3 interface here.
you can extend the VLAN here with port-channel Layer 2.(that is what you are doing now)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide