Cisco SG250-08 Smart Switch Vlan configuration

[prateekpatwalkandai]

Hi All,

I am planning to set up a Homelab and want to configure multiple VLAN's in a single switch port, switch will connect to the Intel nuc PC (ESXi installed). Can I use "Cisco SG250-08 Smart Switch" to achieve this?

in the switch feature it says L2+/L3.. but not sure if it supports it.

Thanks in advance.

regards

prateek

[balaji.bandi · Accepted solution]

yes you can use trunk configuration it should be ok.

[prateekpatwalkandai]

Thanks, @balaji.bandi , configured the trunk, and it's working as expected.

I could see Switch port mode to Layer 3, what is the use case of this ?

[balaji.bandi]

I could see Switch port mode to Layer 3, what is the use case of this ?

you can make the interface as a Layer 3 port-channel with a subinterface if you like to use a Layer 3 interface here.

you can extend the VLAN here with port-channel Layer 2.(that is what you are doing now)