Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
928
Views
0
Helpful
1
Replies

Cisco SG350 stacking question and LAG

roestrye
Level 1
Level 1

‎11-21-2018 03:17 AM

Is it possible to stack two Cisco SG350XG-24F units using 2X 10GB DAC cables totalling total of 20GB link beatween switches?

I have seen some comments that only one cable is being used.

Also can you create LAG inside stack for redundancy in case of one switch failure?

Labels:
0 Helpful
1 Reply 1

Deepak Kumar
VIP Alumni
VIP Alumni

‎11-21-2018 05:01 AM

Hi,

 

The following XG passive cables (Twinax/DAC) are supported on XG350 switches for stacking.
Cisco SFP-H10GCU1m
Cisco SFP-H10GCU3m
Cisco SFP-H10GCU5m
 
(Guide Page number: 67)
 
Also, can you create LAG inside stack for redundancy in case of one switch failure?
Yes.
 
 
Regards,
Deepak Kumar
 
Regards,
Deepak Kumar,
Don't forget to vote and accept the solution if this comment will help you!
0 Helpful
Customers Also Viewed These Support Documents