I got my first 4948 switch.
I configured my management port
Switch>show ip interface brief
Interface IP-Address OK? Method Status Protocol
Vlan1 unassigned YES NVRAM up up
Vlan30 192.168.1.229 YES NVRAM up up
FastEthernet1 192.168.1.226 YES manual up up
ok so I don't understund how to tell everyone in Vlan30 to use "FastEthernet1" as uplink?
If I change cable from FastEthernet1 (mgm port) to GigabitEthernet1/1 than all other network devices in Vlan30 can see internet.
Thanks!