CLI SG200-50

[Dado]

Hi guys.

I am newer in the community. 

I have 5 sg200-50 switches . By default only WEB GUI is enable to management it.

I have found a trick to enable telnet :

- download the configuration.txt 

- Edit it with notepad+

- After the line "username cisco password encrypted d3f1e79cbc683d1f0c4df3c89b31cf71b5494942 privilege 15 " you have to put " ip telnet server"

- Save the file

- Upload the new file .txt on the switch

- copy running* to startup*

Now you are able to connect to the switch >>>>>   telnet <ip address> 6500

But , someone of you known how to enable ssh?

Bye bye

[balaji.bandi]

Look at the command level managment check is that supported ?

[Dado]

Thank you for help.

But when I write copy nvram:sshkey-rsa   it asnwers   "unrecognized command" ..

Have you idea why?

[balaji.bandi]

copy nvram:sshkey-rsa   

 the command is not full right ? what are you copyig ? from where to where ? - check the command sysntax.

[Dado]

Where Can I download ssh-rsa2 key from ?

[balaji.bandi]

copy url nvram:sshkey-dsa

this process for :

SSH Access
The following commands configure user access to the management interface
through SSH.

[charlesmejia771995]

Estimado será que me pueda ayudar con un switch cisco sg200-50p, intente subirlo de versión, primeramente tenia el fireware  1.3.2.2 y lo subí de golpe a la ultima versión 1.4.11.5 despues le di guarda y reiniciar, ahora el sw se reinicia y no arranca.