hi,
What is the best way to connect switch together (with 2960 switch)..cross or stright cable...up/down or normal port ?
WAN ----Router 1 --- -SW1 ---- SW2
|
|
SW3----SW4----SW5 (no vlan)---PC1
all switch has up,down and normal port except SW5
Does SW5 will support vlan if it is connect to a layer 2 switch (let s say sw5 is connected to port 5 of SW4 (and port 5 is VLAN 20 access mode...then trunk between SW3 and SW1))...is there any inheritance ?
Hope, this time, this post will be post on the forum.
Thanks for help,