cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
223
Views
1
Helpful
1
Replies

Delete/deactivate certain port options

Kvothe42
Beginner
Beginner

Hi there,

I tried to setup LAG and now one of my ports has a configuration, I cant remove.
lldp optional-tlv sys-name sys-cap 802.3-power-via-mdi

I dont know where I put a check mark for this to show up in my interface config.

Sadly our cbs350 doenst have the option to just reset the configuration using "default interface".
Any ideas?

Heres a quick look:

interface GigabitEthernet1/0/21
switchport mode trunk
!
interface GigabitEthernet1/0/22
switchport mode trunk
!
interface GigabitEthernet1/0/23
flowcontrol auto
switchport mode trunk
switchport trunk allowed vlan 1-3
lldp optional-tlv sys-name sys-cap 802.3-power-via-mdi

1 Accepted Solution

Accepted Solutions

KJK99
Beginner
Beginner

@Kvothe42 

Switch the web admin to the Advanced mode. Go Administration>Discovery – LLDP>LLDP MED Port Settings. Select the port and edit. A window pops up where you can select/deselect optional TLVs. 

If you can't find a certain setting, always make sure you have the web admin in the Advanced mode.

Kris K

View solution in original post

1 Reply 1

KJK99
Beginner
Beginner

@Kvothe42 

Switch the web admin to the Advanced mode. Go Administration>Discovery – LLDP>LLDP MED Port Settings. Select the port and edit. A window pops up where you can select/deselect optional TLVs. 

If you can't find a certain setting, always make sure you have the web admin in the Advanced mode.

Kris K
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Switch products supported in this community
Cisco Business Product Family
  • CBS110
  • CBS220
  • CBS250
  • CBS350
Cisco Switching Product Family
  • 110
  • 200
  • 220
  • 250
  • 300
  • 350
  • 350X
  • 550X