Does The SG300-10 Support RIP?

[Richard H. Shores]

Hi!

In the CLI documentation for the SG 300 Series, it shows sh ip route rip as a command. I have installed the latest firmware and that command is no longer available. Does the SG300 series support RIP?

Thanks!

Richard S.

[davidagu · Accepted solution]

Hello Richard,

My name is David Aguilar, and I am an engineer with the Cisco Small Business Center. Thanks for writing.

The SG300 Series does not support RIP. Only static routes (maximum of 32) are supported. However, the SG500X models support the RIP version 2 dynamic routing protocol.

In regards to the new Sx300 firmware, it did add a number of impressive security features including IP ARP inspection, DHCP snooping, and SSD encryption.

All the best,

-David Aguilar

Cisco Small Business Support Center

[marko.zaletel]

Hello,

can I ask you where can I find new 1.2.5 firmware verison? I was unable to find it.

Thank you!

Best wishes,

Marko

[Tom Watts]

Marko,

The 1.2.5.70 firmware has been pulled by the business unit. Please continue to use the 1.1.2.0 firmware

[marko.zaletel]

I knew it was too good to last... Will it be added back?

[Tom Watts]

Marko, please follow this post for updates;

https://supportforums.cisco.com/docs/DOC-25157

[marko.zaletel]

Thank you!

Best wishes,

Marko

[anant.saraswat@techblue.co.uk]

Does Cisco SG300-28 support Dynamic routing in L3 mode now ? I want to check because I can see there is an update in firmware.