Hello everyone!
I need to configure data and voice vlan ports and QoS (Quality of Service) on SMB Switch 350X. In switches Catalyst it is only necessary to put the following commands:
config t
vlan 171
name Data
vlan 173
name Voice
interface range gigabitethernet 1/0/1-22
switchport mode access
switchport access vlan 171
switchport voice vlan 173
auto qos voip cisco-phone
exit
but on SMB switches the switchport voice vlan and auto qos voip cisco-phone do not exist. I have searched for information in manuals and forums and I have found that I need the "voice vlan id" command and the smart port of the switch is responsible for doing the rest, but it is not clear how to configure voice and data ports.
Do you configure only the ports in access to the data VLAN and the equipment, having already created a voice VLAN, identifies that it is a telephone when they are connected to the ports and assigns QoS?
Does anyone have an example of how this configuration would be, please
Best Regards