10-10-2023 03:19 AM
Hello everyone,
recently we had our power failure test and the switches were rebooted.
Since the restart, the problem has occurred with 4 of our Cisco SG250 switches that our login password for the admin user no longer works, even though the password was not changed and the switches were saved before the reboot.
Is there a solution how to recover the password?
Or is there an explanation why the access no longer works?
Thank you
Solved! Go to Solution.
02-12-2024 01:43 PM
Hello,
I have an Cisco SG250 too and usually i use the following procedure when my password is not recognized anymore :
I hope this will help you.
Regards,
10-10-2023 03:31 AM
Not sure this could be bug, check any latest firmeware available upgrade it.
below video explain how to reset :
10-10-2023 04:46 AM
Thank you for the fast reply.
Is the linked password recovery method even supported for our SG250 Switches?
The switches had the latest firmware installed
10-11-2023 02:17 AM
I just tried the password recovery method of your video, but not all of our managed Switches have a console port. Does the password recovery method even work in this case?
02-06-2024 05:29 AM
Hello, have you found a solution to your problem? I'm in the same situation...
Thank you
02-12-2024 07:19 AM
Hey, unfortunately I haven't found a working solution yet
02-12-2024 01:43 PM
Hello,
I have an Cisco SG250 too and usually i use the following procedure when my password is not recognized anymore :
I hope this will help you.
Regards,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide