SF100D-16 discrepancy in dimensions

[ajithk001]

We are using Cisco 100 Series Unmanaged Switche, model SF100D-16 in our network drawer for land and OFF-shore use. As per the data sheet on the below link, the dimensions of this product should be 5.12 x 1.52 x 5.12 inches (130 x 38.5 x 130 mm).But our current batch of 40 pieces are of a different dimension. i.e 6.29 x 3.54 x 1.69 inches (160 x 90 x 43 mm)

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps10863/datasheet_C78-582017.pdf

We have  designed an 1U drawer to install this switch based on the dimesions in the datasheet. But now it is not going inside the drawer because of this 5 mm extra height.

Not sure how this descripancy occured between data sheet and physical part. !

Now I am looking for a 16 port with same configuration of model SF100D-16, with 40mm or less height.

Any help  will be heighly appreciated.

Thanks and Best Regards

Ajith

[Tom Watts]

Hi Ajith, there is actually not much descrepency here. I think you have ordered an incorrect SKU on the purchase.

The SF100D-16 is a V02 hardware. The SF100D-16 v01 hardware order SKU is SD216T.

The SF100D-16 V01 is more 'fat' than the SD216T model and is not as long, conversely the SD216T is not as tall but is also longer.

Additionally, take notice the SD216T ports are on the back of the switch while the SF100D-16 the ports are on the front of the switch.

To answer your question, you need to purchase  SD216T to receive the correct size switch.

Please reference these pictures:

-Tom
Please rate helpful posts