I regularly backup the configurations of the SF300 and SG300 switches that we have using http.
This one is balking at doing that with the following message:![SB Internet Switch Backup Config Fails Message.jpg SB Internet Switch Backup Config Fails Message.jpg](https://community.cisco.com/t5/image/serverpage/image-id/63332i67040D67DD8924F6/image-size/large?v=v2&px=999)
The device is in production and I'd rather not have to go on site and fiddle with a serial port.
Presumably I could use telnet with puTTY if I could figure out how to make it work!
Any suggestions would be appreciated!