SF300 Switch

[mrsystemengineer]

Dear All,

          Anybody can support me to configure SF300 48port switch as DHCP Server or not.

My Configuration as below

I have 8 vlan configure in SF300  (SVI with ip address)

isit possible to configure dhcp server and how i can apply access-list to restrict with other vlans.

Advancely thanks.

[Tom Watts]

Hi MRS, at this time the switch does not support a built in DHCP server. You will need an external DHCP server.

-Tom
Please mark answered for helpful posts

[mrsystemengineer]

Hi tom,

            Thanks for your email, i mean before it support DHCPserver?,  I can used external dhcp server and i can assign 4 vlan through external dhcp server, isit possible?

thanks

[Tom Watts · Accepted solution]

Hi, yes you may use an external DHCP server and depending on what you're using it does support multiple scopes. A lot of free programs do not support multiple DHCP scopes.

-Tom
Please mark answered for helpful posts

[mrsystemengineer]

maximum how many scope it will support? i will used windows dhcp server.

before this switch support dhcp server.

regards

[Tom Watts · Accepted solution]

There is no theoretical maximum on Windows

http://technet.microsoft.com/en-us/library/cc786002.aspx

-Tom
Please mark answered for helpful posts

[mrsystemengineer]

Hi tom,

         Thanks for your update about cisco 827 router.  Tom unable to create put command 802.1 on sub interface i am getting error which i was put.  if possible can you send complete command so i will check once again.

But i have one issue that,  i make 827 as dhcp server with 4 scopes and i create sub interface and vlan in sf300 switch, each sub interface have one ip address and same that ip address mention as gateway in dhcp scope.  how i can mention dhcp relay in sf300 switch on sub interface in sf300. if i connect 827 ethernet 0 to sf300 switch port 48.

Thanks for advance.