Hello all. I have two SG350XG-24F (fw ver 2.3.0.130) units in a stack ad they're uplinked to a core device via a port-channel. I wanted to enable sFlow on each of the member interfaces to get an idea of traffic on the individual units. So I set the below config on each and saw traffic getting to my sFlow analyzer:
sflow flow-sampling 1024 1
sflow counters-sampling 60 1
Then I saw these messages below - they seem pretty straightforward but given this is an important stack, I just want to make sure that nothing crazy is happening here.
15-Jun-2021 17:10:17 %STCK SYSL-I-UNITTRP: UNIT ID 2,Trap:%2SWTRUNK-I-TRNKPORTPARAM: auto-negotiation/adv. capabilities of port te2/0/3 differ from auto-negotiation/adv. capabilities of Po3
15-Jun-2021 17:10:24 %2SWTRUNK-I-TRNKPORTPARAM: auto-negotiation/adv. capabilities of port te1/0/3 differ from auto-negotiation/adv. capabilities of Po3
I can't seem to set the same config on the Po3 interface so I can't ensure that it has the same config as the member interfaces. Would this config risk the port-channel setup failing?
