01-27-2012 04:00 AM
Hello,
I have SG300-24 in L2-Mode uplinked to Sonic FW. The only settings that seemed to work is
100Mb Full-duplex on both sides. If there is any other setting like auto-auto or 1000Mbits on both sides link goes down.
I also set portfast enable on the cisco port. Is there anything I need to check to make 1000Mbits work?
PS: L3 mode did not work for us.
Thanks,
Sree.
01-27-2012 10:25 PM
Hi
Your question doesn't indicate which firmware version you have running on the switch,.
Please avail yourself of the newest firmware 1.1.2.0 firmware.
Release notes with this new firmware indicate the following, which may be relevant;
Addressed Ethernet interoperability issues with other devices.
- Negotiation command was modified to add an option that allows you to
configure a Gigabit Ethernet interface to operate in either preferred
master or preferred slave mode during negotiation. The option may help
you to resolve interoperability issue that may arise with other device.
The default mode is preferred slave mode.
- The command was modified as follows:
negotiation [capability [capability2... capability5]] [preferred {master | slave}]
regards Dave
01-28-2012 01:37 AM
Thank you Dave. I will test it out and post in forum.
Our switch on latest firmware.
SW version 1.1.2.0 ( date 12-Nov-2011 time 23:34:26 )
Boot version 1.0.0.4 ( date 08-Apr-2010 time 16:37:57 )
HW version V01
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide