Switches - Small Business

Hello,I was told I need either multiple DHCP server or DHCP server with multiple NIC or the DHCP server is capable to handle 802.1q to make the switch works with DHCP relay.Is that right?Thanks,

如题，在WEB界面用TFTP升级SRW2xxG4_FW_1.2.3.0.ros，重启后，交换机启动不了，超级终端链接后也没有显示。还可以恢复交换机不？thanks.

How do I make the following work with Cisco 302-08G ??I would like to sniff (using wireshark) all traffic in my office. I have a 4-port Cisco wireless/wired router that allows for a guest account. I also have Cisco SF302-08 that I bought so I could u...

Have tried to no avail connecting with a serial cable and Dell D600 to reach the console on this switch.Used the following settings on COM 1 & COM 3 in HyperTerminal:     * Bits per second: 38400    * Data bits: 8    * Parity: None    * Stop bits: 1 ...

Hello all,I just purchased two Cisco switches (SGE2010P) for the new Mitel 5000 Phone System. The Mitel vendor programmed and setup the phone system for us, but they couldn’t figure out the VLAN setup on the my switch. So now I have everything on one...

Hello All, I'm new to the board and a little lost here.. My boss game me a project to work on that he could figure it out. He gave me a SRW2008p switch that has 8 port and 1 gig each port. He wants me to figure out how to configure the vlans on it bu...

Pessoal alguem já configurou o LACP no switch 200 series (SLM2024T) juntamente com algum servidor poweredge T410?

Hi,I have tried to enable jumbo frames by:Go to Port Management >> Port SettingsEnable Jumbo Frames. Click Apply.Save configuration and rebootAfter that I try to verify that jumbo frames is really working by looking at the Status and Statistics >> RM...

Well, I've been learning the eccentricities of Cisco's product lines the hard way!  Here's my situation:I've taken over for an office that has a hosted Cisco IP phone system using a variety of what seem to be older Cisco phones (the one at my desk is...

We have recently purchased a SG300 to break up our network which most consists of virtual machines via Bridged networking on network machines. I have created successfully Vlans and the physical machines are capable of communicating across the differe...

We have about 20 clients on our SBS network. I purchased a SG300-28 about 3 months ago, and at first everything was fine. Then a few weeks ago some users with 100M network cards started reporting that their pc's were very slow. Today I went to those ...

Hello! Can you provide me information, does SLM2008T-EU support DHCP Snooping? I couldn't find it in documentation