01-24-2012 12:58 AM
Hello
I used LACP on port 49 and 50.
After upgrade firmware from 1.0.0.19 to 1.1.2.0 my LAG1 stay down...all port member stay down, port link is up but LAG stay down...
I testtu delete and reconfigure LAG1 but nothing work...
01-24-2012 06:20 AM
Hello DSI
What is the port 49 and 50 connecting to? What is the configuration on that device?
Cisco Small Business Support Center
Randy Manthey
CCNA, CCNA - Security
01-24-2012 08:13 AM
My settings are on SG200-51 Number 1:
Port Management / Port Settings :
Interface | Port Type | Status Port | Speed Duplex | Mode | LAG
GE49 | 1000M-ComboC | Up | 1000M | Full | 1
GE50 | 1000M-ComboC | Up | 1000M | Full | 1
In Port Management / Link Aggregation / LAG Management :
LAG | Name | LACP | Link State | Active member | Standby Member
LAG1 | Networks1 | Enabled | Link Down | | GE49, GE50
In Port Management / Link Aggregation / LAG Settings :
Entry N° | LAG | Descritpion | type | status | auto négotiontion| speed | flow Control
1 | LAG1 |Networks1 | | Down | | |
In Port Management / Link Aggregation / LACP :
Entry No. | Port | Port Priority | LACP Timeout
49 |GE49 |1 |Long
50 | GE50 |1 |Long
I have this problème with some SG200.
In case 1 with a other SG200 with the same configuration for LAG
In case 2 wiith Catayst 2960S with LAG configuration.
But before fireware upgrade on SG200 all work fine!
02-10-2012 10:43 AM
DSI,
I would recommend calling the 1866-606-1866 support number and creating a case, so we can gather further information.
thanks
Cisco Small Business Support Center
Randy Manthey
CCNA, CCNA - Security
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide