Switches - Small Business

What is the switch latency for a SG302-8P for L2 and L3 packets?thanks,Carlos

Hi Everyone, first question i've posted, i'll try and give as much information as possible, i'm an extremely quick learner as well and have been around networking for nearly 20 years but this is my first outing into the medium sized VoIP deployment w...

Hi Guys,I am using around 5 sg300's with a lot of Crestron AV kit / touchscreens. About once every couple of months the touchscreens all stop responding. We have found that a reboot of the Cisco switch attached to the touchscreens brings everything b...

I work for a small business and we have a couple computers that we want to share a ethernet enabled copier/printer with, but for security reasons want to block those computers from internet access.  How would one go about allowing that?Thanks in adva...

Dear Cisco,Can you please explain what is the (best) procedure to configure Auto Voice VLAN???Scenario:Please allow me to explain what I am trying to achieve and the problem I encounter. First of all, I know how to configure Auto Voice VLAN. But I go...

Hi,I am using the CISCO SG300-28 with firmware version 1.0.0.27. I enabled RADIUS authentication and accounting. Authentication is working but there are no accounting requests/replys (Accounting on, accounting off, accoun ting start, accounting stop)...

For having 3 settopboxes for iptv I have setup vlan 3 for iptv.IGMP snooping is enabled for vlan 3 with the default settings and port 5 (incoming iptv) is enabled as IGMP Mrouter.In the multicast forwarding table vlan 3 is set to filter unregistered....

Can I connect a single Cat5e cable between two SG300-28 and link them?  If so what must I configure?

My wireless AP is the WAP4410nMy switch is the SG300-28PMy router is the RVS4000I want to create a guest wireless & an internal use only.It looks easy enough on the WAP, associate a vlan id with the SSID.I did notice after doing this the second vlan ...

Hi,I'm  setting up an SG-300 and would like to block some traffic with ACLs.  While I'm  new to cisco products, I was able to easily setup an IP based ACL to restrict  certain IPs from accessing specific ports, but my problem is with applying these ...

Hello allI am having problem setting up SGE2000P switches to work with my default data VLAN and additional voice VLAN. I am configuring it to pick IP address for phones from voice VLAN which is working fine but when I connect a PC on phone port it is...

I want to make an offer for a public tender for SF200 Switches (P/Ns SLM224GT and SLM248GT). The end user is already using Cat 6 cables and someone from the committee told that these Switches does not support Cat 6 cables and that the SLM224GT doesn'...

I looking to buy SGE 2010 swith, but I have some question:1. Can I use 4 SFP ports and stack of two switches at the same time. 2. Is it possible to use for stacking  ports other than 24, 48?3. What is maximum possible number of ports  to use for stac...

I currently have 2 SG-200-50p's deployed in my network running on a subnet of 192.168.16.x.  Our Aironet Access Points have been configured with 2 SSID's, one for internal network on VLAN 1 and one for a public guess access point pointing to VLAN 10....