SG220-26P-K9 - Voice vlan

[adeebtaqui]

Greetings,

I am having some issue for vloce config for my new SG220-26P-K9

For voice vlan, I had configured ports as access port under data vlan with Voice mode in auto.

But the IP phone were not getting ip address from voice vlan instead were getting from data vlan.

Do I need to change port mode to trunk and allow data and voice vlan only? Which is best practice.

Below is error:

ASW-G(config-if)#interface gi 4

ASW-G(config-if)#voice vlan mode auto

ASW-G(config-if)#voice vlan enable

Port gi4: Voice VLAN State is not OUI-enabled

BHA-HTL-ASW-G(config-if)#

[balaji.bandi]

by default it take as VLAN 1 i guess - can you enable voice vlan as suggested below :

https://www.cisco.com/c/en/us/support/docs/smb/switches/cisco-small-business-200-series-smart-switches/smb99-voice-vlan-configuration-on-the-200-300-series-managed-switc.html