SG250-10P PoE to Aruba AP

[dpditstaff]

We have an SG250-10P switch connected to Aruba Instant APs.  The switch does not seem to be providing the adequate level of power to the APs to activate the radios.  Are there specific settings associated with the switch to set the power level for the APs?

Thanks

[balaji.bandi]

how many radios you have connected what is the Model of Aruba? what kind of PoE requirement for the AP?

check the PoE calculation and support on the datasheet : (Product specifications)

https://www.cisco.com/c/en/us/products/collateral/switches/250-series-smart-switches/datasheet-c78-737061.html

[dpditstaff]

Thanks for the response.

The APs are the Aruba APIN0535 and the AP-207.

For the APIN0535 the power requirements are as follows:


-
- POE powered (802.3bt or dual 802.3at): 26.4W
- POE powered (802.3at, IPM disabled): 23.3W
- All numbers above are without an external USB device connected.
When sourcing the full 5W power budget to such a device, the incremental
(worst-case) power
consumption for the AP is up to 5.7W ( POE powered) or 5.5W ( DC
powered).
- Maximum (worst-case) power consumption in idle mode: 13.3W ( POE) or
14.3W (DC)
- Maximum (worst-case) power consumption in deep-sleep mode: 3.8W (POE)
or 3.6W (DC)
- Does the SG250 support these power requirements with LLDP enabled?

Thanks