Re: SG300 / Wrong module type 63,Board will be rebooted

tpruitt2410 · ‎05-25-2020

Hello,
i have a big problem with the SG-300 -10MPP switch after my trainee tried to update the device.
Nothing works anymore, no reset , no network connections, the System light is blinking and via Putty i only get this message.
What happend and what can i do?

Any ideas?
Thanks

marce1000 · ‎05-25-2020

- Depends on what the trainee did, looks like wrong firmware was installed. You may try a factory defaults reset of the device. If that does not help things are worry some.

M.

-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

mihail_ip · ‎05-31-2020

Hello,

Can you enter boot menu (startup menu) and what you see there?

Regards

Mike

tpruitt2410 · ‎06-01-2020

Hi, thanks for your help.
I send the Device back to Cisco.