09-18-2019 10:55 PM
i have this switch and i have ubiquiti Access point ( unify ac lite ) see attached photo
this AP wirks using POe ports. i cant power any AP. i read that class and limitaions found and i know my access works on 6.5 wt but i do no know how to change to class 2- or let switch power my AP
09-19-2019 12:52 AM
Check the cable. Possible it is damaged.
Switch autodetect class. Class 0 is enough for work.
09-19-2019 01:49 AM
Hi,
By default PoE ‘Power Mode’ is Class Limit in SG350 Switch. You may disable the PoE class error detection on the switch once and check. With this setting, if a class error is detected on an interface, it will be ignored and PD will be classified as class 0.
To disable PoE class error detection, use the power inline class-error-detection Global Configuration mode command. To return to default setting, use the no form of this command.
Syntax
power inline class-error-detection [enable|disable]
no power inline class-error-detection
Example:
switchxxxxxx(config)# power inline class-error-detection disable
Note: Please make sure the SG350 switch firmware is latest (2.5.0.83).
https://software.cisco.com/download/home/286288281/type/282463181/release/2.5.0.83?i=!pp
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide