Hello Everyone,
I'm working with an organization that 400+ computer users. We bought cisco smart switch sg250 for purpose that will help our network avoiding the network loop. There are 6 sg250 /24 ports switch that we planned to configured as a non root switch plus the other sg250/24 ports that we plan to be configure as a root bridge sw. This is our first time using the cisco product and we want to managed each switch.
However, it been 2 months since we use this topology but we still encounter network dropped or loop sometime and I have hard time to trace. I've also trying a figured out if I miss configured our cisco sg250 /24 port switch STP protocol.
The following steps i was went through when i configure my STP
===================================================
1. Elect root bridge
2. Place root interface into a Forwarding State
3. Each non-root switch selects it root ports
4. Removing Links choose a designated ports
5. all other ports are put in a Blocking State
I do need some extra solution for cisco sg250 /24port STP configuration in-order for my department to protect from network loop.
