16amp or 32amp power breaker required

[sgooding]

Hi Cleaver Cisco People ,

For the asr-9910 is a 16amp or a 32amp breaker required .

Same question for the ASR-9906 & 9904 .

UK based 

Regards

[marce1000 · Accepted solution]

  - Overall power consumption will depend on what modules are being used on the devices too ; 
    start with : https://cpc.cloudapps.cisco.com/cpc/launch.jsp

 M.

[sgooding]

Thank you for your reply , I have not seen the build spec yet . I have a project soon to rack these devices and survey power availability but that’s hard to do when I have not been given the info on power modules that have been installed so unsure if I should be looking for 16 Or 32a outlets , . Don’t even know what power cables are required , if they are c15,c19,c21 ends that connect into the modules . Thanks for the power table link I’m sure it will help .

[Reza Sharifi · Accepted solution]

Hi,

https://www.cisco.com/c/en/us/td/docs/iosxr/asr9000/hardware-install/overview-reference/b-asr9k-overview-reference-guide/b-asr9k-hardware-installation-guide_chapter_011.html

Have a look at Table 3.

Source AC service requirement

20 A North America; 16 A international; 13 A United Kingdom

[sgooding]

Thank you for that. Was thinking it would possibly creep up to needing a 32a socket depending on the cards the device was specked with.

[Reza Sharifi]

You should not need 32a. According to the document, for the UK, 13 a.m. per circuit should do it.

HTH

[sgooding]

Thank you