05-20-2007
06:30 AM
- last edited on
03-25-2019
03:54 PM
by
ciscomoderator
I am trying to install a NM-ESW-16 into a 2610 router. The router is running IOS 12.3 (21). When I do a SH DIAG is shows that in Slot 1 and UNKNOWN (type 681) PORT ADAPTER. Further down it gives additional information, such as harware revision, serial number, and shows that the Product Number is NM-16ESW.
Any idea why this device does not show up when I do a SH IP INT? Is there some additional installation/configuration that I need to perform to enable this device?
Yes, I have removed and reseated this module. When the router boots up the lights come on and then go out after the POST is completed.
Any ideas would be a great help.
mike
05-20-2007 10:51 AM
Hi,
I think you need at least a "plus" image for the ESW modules, what feature set are you running?
Andrew.
05-20-2007 11:22 AM
Hi,
Cisco Etherswitch Modules are supported in IP Plus or above in Cisco IOS releases 12.2T. Beginning with Cisco IOS 12.3 Mainline and 12.3T, the Cisco Etherswitch modules are supported in IP Base or above.
I'll take a wild guess that this module is not supported on the 2610, let me check it out.
HTH, please do rate all helpful replies,
Mohammed Mahmoud.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide