04-02-2013 05:18 AM - edited 03-07-2019 12:35 PM
Hi
I request help.
How to configure a module NM-16ESW because with the command "show diag" and "show int" can not query it.
Note: the default IOS is installed, you will need to upgrade to a specific '.
thank you
Luiz Fernando
04-02-2013 05:27 AM
Hi,
Yes, you need 15.1 or later software on your device.
Have a look at this doc for config examples:
http://www.cisco.com/en/US/products/hw/modules/ps2797/products_configuration_example09186a00808066b8.shtml
http://www.cisco.com/en/US/prod/collateral/routers/ps259/product_data_sheet09186a00801aca3e.html
HTH
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community