10-08-2016 06:51 PM - edited 03-08-2019 07:44 AM
hi all,
we have currently PSTN -> E1R2 2901 -> H323 line PBX -> phone. config is working both ways. only issue i have is when the PBX receives the call from the 2901 voice gateway, it receives the ANI/caller ID but with the Cisco Systems Inc after the ANI. so the phone display it show 555-1111 Cisco Systems Inc. can't find any reference on the router config for the Cisco Systems Inc. can I remove that so only the ANI shows?
using IOS 15.4. we also used a 2900 router during POC but it does not show the Cisco Systems Inc so i think it is a new IOS thing. will also provide the IOS version we used before once i have it confirmed. router config below
version 15.4
card type e1 0 0
no aaa new-model
network-clock-participate wic 0
network-clock-select 1 E1 0/0/0
ip cef
no ipv6 cef
multilink bundle-name authenticated
isdn switch-type primary-net5
voice-card 0
voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
no supplementary-service h450.2
no supplementary-service h450.3
supplementary-service h450.12
fax protocol t38 version 0 ls-redundancy 0 hs-redundancy 0 fallback none
h323
sip
controller E1 0/0/0
framing NO-CRC4
ds0-group 0 timeslots 1-15 type r2-digital r2-compelled ani
cas-custom 0
country philippines use-defaults
controller E1 0/0/1
interface GigabitEthernet0/0
ip address 172.18.0.17 255.255.240.0
duplex auto
speed auto
h323-gateway voip interface
h323-gateway voip id CO ipaddr 172.18.0.2 1719
h323-gateway voip h323-id CO
h323-gateway voip bind srcaddr 172.18.0.17
voice-port 0/0/0:0
dial-peer voice 1 voip
description to PBX
destination-pattern .T
session target ipv4:172.18.0.2
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
dial-peer voice 2 pots
incoming called-number .T
direct-inward-dial
port 0/0/0:0
10-09-2016 06:40 PM
This is the Video Over IP community, you might want to move this other collaboration subjects area.
10-09-2016 07:11 PM
ye i was thinking creating it in the router section but thought more people in this community have more experience with the subject
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide