06-12-2010 05:36 PM - edited 03-06-2019 11:33 AM
ok im trying to set my FastEth port 3 into sticky security, but when i go to enter commands this is what i get:
BasementSwitch>en
Password:
BasementSwitch#config t
Enter configuration commands, one per line. End with CNTL/Z.
BasementSwitch(config)#int fa0/3
BasementSwitch(config-if)#switchport access?
access Set access mode characteristics of the interface
mode Set trunking mode of the interface
multi Set characteristics when in multi-VLAN mode
priority Set 802.1p priorities
trunk Set trunking characteristics of the interface
voice Voice appliance attributes
BasementSwitch(config-if)#switchport access vlan 1
BasementSwitch(config-if)#switchport port-security ?
% Unrecognized command
can someone help me with this, thanks.
06-12-2010 06:15 PM
This is what you should see after ?
Management-Switch(config-if)#switchport port-security ?
aging Port-security aging commands
mac-address Secure mac address
maximum Max secure addresses
violation Security violation mode
Management-Switch(config-if)#switchport port-security
maybe port securiy in not supported
06-12-2010 06:18 PM
yea w
hen i boot it says i downloaded the LRE image, im downloading the non LRE and hopefully that will help
06-12-2010 06:41 PM
be careful
LRE image may not work on a regular 2924
06-12-2010 06:50 PM
yea i just nopticed at boot it says that my 2924XL isnt LRE compatable, so i am re uploading a non LRE
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide