Switching

I'll try best explain the setup/senario:Senario:You're company is merging (buying out) with another company. The other company is very small (a single site that will be connected by fiber) and has one (L2) network which runs on a non-Cisco switch and...

HiI know that in this mode, when the first host authentication fail, the remaining host are limited too. But is it posible that each host can be autheticated separately without being affected for the firs host, when it fails.

Hi all,I deployed QoS on 3750 and i want to know if the previous marked packets are in the right queue.On the router we can do that with sh policy-map interface fastetehrnet 0/0 output for exempleis there any equivalent command??Thanks for helpMalek

Hi,We are keep getting the following error when trying to telnet to our Cisco6509 switch with sup1A and msfc1.same error occur if try directly telnet to msfc or through cat mod with session 15."unable to tunnel to router-15 (57)"only way to fix is re...

HiAttached is the schematic.As shown in digram am tracking fastethernet of switch 1 and decrementing the priorty to amke switch1 standby.even when fast ethernet going down priority decrementing by 10 but switch 2 not becoming ACTIVE.even when the gig...

Hi for everyoneplease i need to help in how can i interprate the cisco IOS name like c2600-ipvoice-mz.123-7,T3.bin thanks for help

Do C2950-24port support those? My image is latest 12.1(22) EA13.Can't seems to find the cmd there.Therefore cant do any bandwidth limitation on interface fa.Any idea?

We intend to create a seperate vlan segment specially for use by servers to backup their data, so that these servers say seperate from other vlans & dont interrupt or consume resources due to their high volumes.Idea is to have extra interface cards o...

Hi ,Is there any way to enable ip accouting on gig (EoSDH link is terminated between Site A and site B) of 4507 R switches...Site A (Gig 3/45) -- EoSDH link -- (G3/45)Site B.I want to analyze the traffic which is traversing through 10 Mb EoSDH link b...

I would like to limit the user bandwidth once it enter the switch. For exmaple, limit the bandwidth to 512Kbit/s.Shld I use port-limit or policy-map? My software version is 12.1(22)EA13.Thanks for helping out!

Hi, from a given interface, I attempted to do for testing:#ip igmp join-group <IP>and the command was refused stating that can't be done on SSM.Do you know the command to join-group in SSM then?

I am currently using a 24 port 3750 as a core switch hooked up to an ASA 5520 firewall. I am upgrading the switch to a 48 port 3750. Currently I am using OSPF on the switch and firewall to share routes. I started configuring the new 48 port to rep...

Setup: NAS connected to one Cisco 3560 with 1Gb/s interface. Trunk from 3560 to 6509(a) with 1Gb/s. Trunk from 6509(a) to another 6509(b) with 10Gb/s. One port with 1Gb/s connected to a windows 2008 server.The 6509 are configured with VRF's, VLAN's ...

I have issues across two 4500 switches interconnected by pry and backup link.The Pry(prymary) link is a Lan eXtensionThe Backup link has additional swithces in between performing Q-in-Q(L2TP)on the two 4500 switches pry and Backup links interfaces ar...