I'm looking for some information on how I should stack these switches. They don't have stack cables/ports, and the guide says they support virtual stacking. Unfortunately, I'm not entirely sure how to configure this. Is this speaking about clustering? I see the vstack command, but I don't see any of the vstack commands in the guide after enabling it. See here:
(config)#vstack ? director Configure director's IP address <cr>
(config)#do sh vstack config Capability: Client Oper Mode: Enabled Role: Client Vstack Director IP address: x.x.x.x
System image file is "flash:c2960l-universalk9-mz.152-6.E/c2960l-universalk9-mz.152-6.E.bin"
Model number : WS-C2960L-48PQ-LL
Any information you can provide is greatly appreciated. Thanks!
Do you use Cisco DNA Center? Have you used and are you willing to provide your feedback in using the Cisco DNA Center help and documentation?
If so, we’d like you to complete the survey linked below. Your feedback will help provide more effective and easi...
Listen: https://smarturl.it/CCRS9E18Follow us: https://twitter.com/CiscoChampion Reaching the height of your career is no simple feat. It often requires a combination of pursuing the right education, building the right professional network and being ...
In a typical production SD-WAN deployment, we would probably have many remote sites connected via many different Internet connections to a centralized data center or a regional hub. In most regions in the world, Internet providers will always use some typ...