05-28-2012 10:14 PM - edited 03-07-2019 06:57 AM
Hi ,
Facing issue with 2960G switch , where its do not display "logging trap informational " in show running and show startup .where its showing all other levels from 0 to 5 and 7 after configuration and save commands .
the steps used to configure -
sw(confg)#loggig trap 6
sw(config)#exit
sw#wr
sw#show runn | i logging
sw# --------------> (no match)
after config getting saved , it do not shows in show runn or in show startup while for all other levels it do show the config lines .
I tried the same on 12.55.SE release also but its same results .Please let me know is this a limitaion of this platform, is there any doc explaining the same for reference .
sh ver snap from switch-
SW2 uptime is 2 days, 5 hours, 3 minutes
System returned to ROM by power-on
System restarted at 08:29:28 IST Sat May 26 2012
System image file is "flash:c2960-lanbasek9-mz.122-44.SE6/c2960-lanbasek9-mz.122-44.SE6.bin"
cisco WS-C2960G-24TC-L (PowerPC405) processor (revision F0) with 61440K/4088K bytes of memory.
Last reset from power-on
1 Virtual Ethernet interface
24 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
64K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:26:51:48:BA:00
Motherboard assembly number : 73-10015-07
Power supply part number : 341-0098-02
--More-- Model revision number : F0
Motherboard revision number : A0
Model number : WS-C2960G-24TC-L
System serial number :
Top Assembly Revision Number : B0
Version ID : V04
CLEI Code Number : COMFX00BRA
Hardware Board Revision Number : 0x01
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 24 WS-C2960G-24TC-L 12.2(44)SE6 C2960-LANBASEK9-M
Configuration register is 0xF
SHCIL-MHDC-Ext-SW2#sh fil
SHCIL-MHDC-Ext-SW2#sh file sy
SHCIL-MHDC-Ext-SW2#sh file systems
File Systems:
Size(b) Free(b) Type Flags Prefixes
* 32514048 22090240 flash rw flash:
- - opaque rw vb:
=========
Thanks for reply
Solved! Go to Solution.
05-29-2012 12:33 AM
Hi,
The default trap level is "informational" and as such it is not displayed in the config file. Please see the reference for 12.2 IOS beneath:
http://www.cisco.com/en/US/docs/ios/12_2/debug/command/reference/dbfintro.html#wp1017299
You can check the trap level configured via the "sh logging" command.
Best regards,
Antonin
05-29-2012 12:33 AM
Hi,
The default trap level is "informational" and as such it is not displayed in the config file. Please see the reference for 12.2 IOS beneath:
http://www.cisco.com/en/US/docs/ios/12_2/debug/command/reference/dbfintro.html#wp1017299
You can check the trap level configured via the "sh logging" command.
Best regards,
Antonin
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: