09-02-2018 09:02 PM - edited 03-08-2019 04:03 PM
Hi All,
I'm hoping to configure a port as a l2protocol-tunnel. I don't see the command available when using question mark on a switchport mode access port.
Can a 2960 XL running 15.2 utilize l2protocol tunnels?
Solved! Go to Solution.
09-05-2018 02:38 PM - edited 09-27-2018 09:30 PM
WS-C2960X-24PS-L
It appears this model can't perform L2p. High probability that the XR can.
if you upgrade the X to 15.2.6 you can create q in q tunnel (not specific with vtp/stp/cdp)
Closing..
09-02-2018 11:51 PM
09-05-2018 02:38 PM - edited 09-27-2018 09:30 PM
WS-C2960X-24PS-L
It appears this model can't perform L2p. High probability that the XR can.
if you upgrade the X to 15.2.6 you can create q in q tunnel (not specific with vtp/stp/cdp)
Closing..
06-25-2024 06:05 AM
this is an old thread, I know... Just to fix the accepted solution:
#show inv
NAME: "1", DESCR: "WS-C2960X-48FPD-L"
no XR - can run dot1q-tunnel fine:
interface GigabitEthernet1/0/13
switchport access vlan 4094
switchport mode dot1q-tunnel
spanning-tree portfast edge
but no "l2protocol-tunnel {cdp|lldp|...}"
(config-if)# l2?
% Unrecognized command
so - only software-release dependent, not about X or XR.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide