02-26-2013 08:09 AM - edited 03-07-2019 11:56 AM
Hi there,
I had a bad power surge yesterday that took out a 2960g switch and the APC UPS that it was connected too. when plugged in the fan comes on and the syst light stays amber and the rps, stat, duplex. and speed light stay lit and the port lights for ports 21-24 stay lit. plugging it into the console on boot I cant even see rommon, so i dont think its even booting. I would like to find a pinout and voltage guide for the connector comming off the power supply so I can check the voltages coming off the power supply to tell if it is a bad PSU or if it took out the main board.
thanks.
Jason Hill
02-26-2013 08:42 AM
I know it's not exactly what you are looking for, but if this switch was pluged into an APC UPS, thier equipment protection policy should replace it regardless of what is wrong with it. Here are some intructions on how to file an EPP claim.
02-26-2013 09:52 AM
thanks for that info, Ill look into that, id still like to find out what exactly happened to this thing.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide