It actually seems like it is a "smart managed" model that no configuration from the CLI is possible. It looks like you are supposed to connect your laptop to a switch port which assigns a IP address via DHCP and then connect in the web browser to the default 192.168.1.1 ip address and do all configuration via GUI. The CLI seems to only be for monitoring and no configuration whatsover. I can do a show run but not config t. output of ? is below.
Switch#?
Exec commands:
access-enable Create a temporary Access-List entry
access-profile Apply user-profile to interface
access-template Create a temporary Access-List entry
archive manage archive files
authentication Authentication options for eEdge
beep Blocks Extensible Exchange Protocol commands
bulkstat Bulkstat exec commands
calendar Manage the hardware calendar
call-home Call-Home commands
cd Change current directory
clear Reset functions
clock Manage the system clock
cns CNS agents
connect Open a terminal connection
copy Copy from one file to another
crypto Encryption related commands.
debug Debugging functions (see also 'undebug')
delete Delete a file
device device classifier
diagnostic Diagnostic commands
dir List files on a filesystem
disable Turn off privileged commands
disconnect Disconnect an existing network connection
do-exec Mode-independent "do-exec" prefix support
dot1x IEEE 802.1X Exec Commands
eap EAP Exec Commands
enable Turn on privileged commands
erase Erase a filesystem
exit Exit from the EXEC
format Format a filesystem
help Description of the interactive help system
if-mgr IF-MGR operations
ip Global IP commands
lock Lock the terminal
logging Handles logging operations
login Log in as a particular user
logout Exit from the EXEC
macro Exec level macro commands
mkdir Create new directory
monitor Monitoring different system events
more Display the contents of a file
name-connection Name an existing network connection
no Disable debugging functions
ping Send echo messages
pnpa PnP agent
port-channel lag auto persistent
pwd Display current working directory
rcommand Run command on remote switch
release Release a resource
reload Halt and perform a cold restart
rename Rename a file
renew Renew a resource
rep Resilient Ethernet Protocol Exec Commands
resume Resume an active network connection
rmdir Remove existing directory
routing-context Routing Context
rsh Execute a remote command
send Send a message to other tty lines
set Set system parameter (not config)
setup Run the SETUP command facility
show Show running system information
software Software commands
spec-file format spec file commands
ssh Open a secure shell client connection
staging execute boot stage parameters
systat Display information about terminal lines
tclquit Quit Tool Command Language shell
tclsh Tool Command Language shell
telnet Open a telnet connection
terminal Set terminal line parameters
test Test subsystems, memory, and interfaces
traceroute Trace route to destination
tunnel Open a tunnel connection
udld UDLD protocol commands
undebug Disable debugging functions (see also 'debug')
upgrade Upgrade commands
verify Verify a file
vtp Configure global VTP state
where List active connections
write Write running configuration to memory, network, or terminal
Switch#
