I attempted to upgrade single switch using the archive-sw /overwrite command. The new firmware appears to have installed and there is room on the flash.
However when it boots it doesn't "see" any of the interfaces or the config. I get the following error:
Switch#sh run
Unable to get configuration. Try again later.
Locked by -1
Unable to get configuration. Try again later.
Locked by -1
Switch#
Mar 30 01:29:45.842: %SCHED-7-WATCH: Attempt to lock uninitialized watched semaphore (address 0). -Process= "Exec", ipl= 0, pid= 3
-Traceback= 46CBC0z 17F77D0z 4781E4z 478338z 47B9C4z 47BA54z 41B454z 3B54C0z 3BB844z 3CB5ACz 214E980z 214AD00z
I cannot save any configuration, nor are there interfaces. It gives me an "invalid command" error when I try dir flash:. I can see it initialize flash during boot.
Anyone have any ideas how to fix this?