2960S config

[Sean McCoy]

Trying to configure a 2960s stack. I stacked the switches and everything looks fine when I look at it via console connection. I have the VLAN 1 IP address configured for the stack. I put an address on the laptop in the same subnet. I cannot connect via the IP address assigned to VLAN 1. Did I miss something?

[Reza Sharifi]

Sean,

did you create an SVI for vlan 1?

interface vlan 1

ip address 10.10.10.1/24

no sh

is the vlan in up and up mode?

[manju.cisco]

Hi,

I guess the port on the switch connectingn to the PC has been configured as trunk port.

Can you pls configured it as access port? It should ping then

Make sure you have not configured the port to different access vlan by mistake

If this still doesnt ping, pls post us your configuration and interface status.

Manju