I have a number of remote 2960X units which are connected to a Cisco RSP2300 unit for power redundancy.
I noticed that one of the switches is being powered by the RPS unit. I have rebooted it, and it continues to show it's being powered by the RPS.
I have run the command show env power and it's returning this:
SW: 1
PID: Built-in
Serial#
Status
Sys Pwr: Unavail
PoE:
Pwr Watts:
Would that Sys Pwr: Unavail indicate the PSU has gone? Is there any other way to remotely check this?