Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a network with a 3650 backbone switch, and 5 * 2960 clients switches. I was just reading an article about STP, and it mentioned it's important that all switches in the network are on the same vesrion. All the 2960s are running 15.2(2)E7 but th...
I have a number of remote 2960X units which are connected to a Cisco RSP2300 unit for power redundancy.I noticed that one of the switches is being powered by the RPS unit. I have rebooted it, and it continues to show it's being powered by the RPS.I h...
I have 2 * WS-C3650-48TS switches running 16.6.3 When I add Port Descriptions from the web GUI (Configuration -> Physical Interfaces) it appears to save them, but then after a time (I'm not sure exactly how long, but lets say a few days) they disappe...
Hi, I am running Hyper-V on Svr2016. I have created a NIC team of 3 physical ports in Switch Independent mode with Hyper-V Port distribution. This is then used for my external virtual switch in Hyper-V and all the VMs use this. The Hyper-V server i...
Hi, My Cisco 2960 switch encountered issues over the weekend causing 2 of the ports to go into Err-disable mode. I have managed to rectify the problem, however I want to know if it's possible to view logs from the CLI to try and figure out what cau...
Hi Giuseppe,Thanks for the reply. I ran the command and could see the interface descriptions which I just added.It didn't show me the last time configuration has changed and last time configuration has been saved though - do I need to run another com...
For anyone else having this issue (the Express Setup doesn't work, and neither does the default username and password) you have to configure through the switch through the CLI using the "Initial Configuration" setup procedure.
Also important to no...
Many thanks for the reply Daniele. It looks like that's from the "Recovering from a Lost or Forgotten Password" section, and I may try that as a last resort, but I'm quite concerned that these are new units and why they would be in that state.
Wha...
