02-24-2015 08:40 AM - edited 03-07-2019 10:49 PM
I have a 2960X switch that has the stack speed at 10G. I can't for the life of me figure out how to set it back to 20G. Thanks for your help, Joe.
Solved! Go to Solution.
02-26-2015 11:51 AM
Hi,
You can revert the speed back to 20G (default) via the (global) configuration command:
"no sw stack port-speed"
Best regards,
Antonin
02-24-2015 09:15 AM
Hello, kmolino6294.
I assume you already have the FlexStack module on each of your 2960-X switches? You can also check FlexStack-Plus for a higher stack throughput.
https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-2960-x-series-switches/white_paper_c11-728327.html
Let me know if you have additional concerns or e-mail (adawa@cisco.com) me directly. Kind regards.
02-24-2015 09:29 AM
All switches have a module and all are using the same version.
I am trying to change the Stack Ring Speed below from 10G to 20G.
Switch#show switch stack-ring speed
Stack Ring Speed : 10G
Stack Ring Configuration: Down
Stack Ring Protocol : FlexStack
Switch#
The other 2 switches are 20G.
Thanks for your help. Joe.
02-26-2015 11:51 AM
Hi,
You can revert the speed back to 20G (default) via the (global) configuration command:
"no sw stack port-speed"
Best regards,
Antonin
02-26-2015 02:22 PM
Thank you very much! Joe.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide