cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1730
Views
0
Helpful
15
Replies

2x 3750 Stacks

CobbyJ
Level 1
Level 1

Hello

 

We alredy have a 3750 stack as master and slave working as core switches which has routing and vlans and working as gateways and we want a second stack with master and slave connect via CAT 6 as its in a completly different room and cant use the stack cables

 

My question is if we add the same vlan routes and gatewats and ip routes would that cause issues as it would loop? and is there a way around that?

 

And also on our second stack we are having issues getting it into the master and slave roles. we have followed the guide and turned off the slave and then turned on the master and then the slave but it still shows up as member. they are both the exact same switch and same firmware - any ideas on that?

 

Kind Regards,

Chris

15 Replies 15

Hello

On the cores links connecting to the access switch:

int/x
spanning-tree vlan xx port-priority yyy < higher value less preffered


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Review Cisco Networking for a $25 gift card