30W POE+ on WS-X6148E-GE-45AT

[Alan Yee]

We have a 6506-E with VS-S2T-10G supervisor engine with 15.1(02) IOS. The WS-X6148E-GE-45AT is in slot 3.

WS-X6148E-GE-45AT should support POE+. But in the comannder line I can see the port max power is 15.4W.

I try to use (config-if)>power inline static max  

to set the power to 30W. But it only supports from 4000 to 16800 (POE range)

What should I do?

Here is the data sheet.

http://www.cisco.com/c/en/us/products/collateral/switches/catalyst-6500-series-switches/product_data_sheet0900aecd8017376e.html

[Reza Sharifi]

This blade supposed to be POE+ and the range should be 4000-60000.

So, either the documentation is incorrect or the blade does not support 30w.

Open a TAC case

HTH

[Masoud Pourshabanian]

Hello,

It only supports POE+ if daughtercard is installed. Does it have daughtercard installed?

Please check page 2 on the link below.

 You should be able to see it in the out put of show module. Something similar to this :WS-F6K-48-AF(daughtercard)

http://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/power_over_ethernet.pdf

Masoud