12-18-2006 05:50 PM - edited 03-05-2019 01:23 PM
I have been given a configureded 350 seires bridge (static Ip address) that I am trying to install on my home network. But when using the device Mac address with the Cisco IPSU software to get the ip address assigned to the bridge, there is no reply. How can I reset this bridge to DHCP so I can install it on my home network?
Any help would be appreciated.
thanks
12-19-2006 09:54 AM
Hi
(1)Are you using the bridge with PoE or AC adapter?
(2)There is a reset button on your bridge.Try inserting a pin into that and see.
(3)Third option is to connect through console and reset that.
Pls visit the following page for full troubleshooting doc.
http://www-tss.cisco.com/eservice/compass/common/activities/password_aironet.htm
Regards
JD
01-21-2007 03:10 PM
Hi, answers to your answers:
1. AC Adapter
2. doesn't work - there doesn't seem to be a button to push when I instert a paper clip???
3. I don't have a 9pin cable
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide