3550SMI upgrade

[Patrick McHenry]

I'm going to upgrade a 3550 switch from c3550-i9q3l2-mz.121-13.EA1a  to  c3550ipservices9-mz.122-44.SE6.bin.

This will make it a EMI correct?

Is there anything else I have to install to make it a layer 3 switch?

My current flash shows 10,728,448 bytes free and the new image is 9,707,290 bytes.

I should be all right, correct? I'm always paranoid about the size.

If the flash is bigger than the image that I am installing, even by 1 byte, it should be ok?

Thanks, Pat.

[Roman Rodichev · Accepted solution]

Yes EMI, you'll be ok. You can also always delete the existing image, copy the new one, and reboot.

[kapathak · Accepted solution]

You should be good to go. You can always delete the existing image on the flash to free up some space. But I don't think that should be necessary at this moment considering the image size and the free flash space.

Cheers!