Re: 3560 NAT Support or not

Sunish Nair · ‎07-04-2010

Hi,

I would like to know 3560 Switch support NAT or not

Regards,

Sunish

Giuseppe Larosa · ‎07-04-2010

Hello Sunish,

NAT is not supported on C3560.

Only C6500 with Sup720 supports hardware assisted NAT

you likely need to deploy a sw router to perform NAT

Hope to help

Giuseppe

Ganesh Hariharan · ‎07-04-2010

Hi,

I would like to know 3560 Switch support NAT or not

Regards,

Sunish

Hi Sunish,

No cisco 3560 does not support nat functionality, only 6500 and 5500 series with min ios 11.2 (P) series support in switches seires.

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

hobbe · ‎07-04-2010

The 3560 does NOT support NAT,

However there are/can exist NAT commands in the IOS for the 3560 switches but the commands do not work.

When you type the command it does not say it does not work it accepts it just as it should work, but it just does not do anything.

good luck

HTH

SERGIO GONZALES · ‎08-16-2011

However... on packet tracer 5.3 still works !!!

Good Luck

johnlloyd_13 · ‎08-16-2011

hi sergio,

yes in PT, the 3560 does support NAT. however, in real switches it's not.

PT:

Switch#sh ver

Cisco IOS Software, C3560 Software (C3560-ADVIPSERVICESK9-M), Version 12.2(37)SE1, RELEASE SOFTWARE (fc1)

Compiled Thu 05-Jul-07 22:22 by pt_team

Image text-base: 0x00003000, data-base: 0x01500000

Switch(config)#ip nat ?

inside Inside address translation

outside Outside address translation

pool Define pool of addresses

-------

real 3560:

C3560#sh ver

Cisco IOS Software, C3560 Software (C3560-ADVIPSERVICESK9-M), Version 12.2(46)SE, RELEASE SOFTWARE (fc2)

Compiled Thu 21-Aug-08 15:26 by nachen

Image text-base: 0x00003000, data-base: 0x01A00000

C3560(config)#ip nat ?

% Unrecognized command