3850 Stack Switch Shutdown Simulation

[avilt]

I have a 3850 stack with 2 switches and stack power. I have a simulation test where I am required to shutdown one switch at a time. The switches also have stack power so pulling the power cable will not help. So I am planning to use  the below procedure, please advise whether my procedure is right.

SW#power supply 2 slot A off
SW#power supply 2 slot B off

Now pull the power cable of the desired switch.

At the end execute the following command.
SW#power supply 2 slot A on
SW#power supply 2 slot B on

[balaji.bandi]

Depends on how you configured for the Stack Power :

Take example if you have 2 switch and have stack power configured.

Switch 2 lost the power, Switch 1 will be provided power to Switch 2.

show stack-power  - can you post output to have look

show run

[Leo Laohoo]

If you want to simulate a switch shutdown (as close as possible to a live one), then pull the power cords.