Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
443
Views
0
Helpful
1
Replies

6500 Crash info Vs Exception dump

wbpo
Level 1
Level 1

‎11-22-2007 12:00 AM - edited ‎03-05-2019 07:34 PM

Can some one help me in configuring "exception dump" in 6500 L3 switches. This is mainly for collecting the info during any switch crash.

Pl clarify the difference between Crash info feature & Exception dump feature in 6500

Labels:
0 Helpful
1 Reply 1

mchin345
Level 6
Level 6

‎11-28-2007 06:46 AM

Use the show log command you can see reset manually by the user or caused by a crash and also if there have been any exceptions. Exceptions are CPU dumps that occur immediately after a crash, as shown in this example: MCP Exceptions/Hang: 0

show logging buffer 1023 command displays all system messages, including possible error messages that may relate to the crash

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card