10-19-2020 02:39 AM
Hi, my switch in the rmon mode, can't boot . Please guide me to fix it :
10-19-2020 02:51 AM - edited 10-19-2020 02:53 AM
below guide for reference :
10-19-2020 03:20 AM
compressed image checksum is incorrect
This means the IOS file is corrupt.
10-19-2020 06:13 PM - edited 10-19-2020 06:16 PM
Yes. ! how can i turn off auto boot to set new ios?? , I turn the power off and open again, but it still boots ...
10-19-2020 06:49 PM
In ROMMON, post the complete output to the command
set
10-19-2020 07:36 PM
This is output
10-19-2020 08:11 PM
So you want the line card to "always boot" into ROMMON? Is this the intention?
10-20-2020 12:28 AM - edited 10-20-2020 01:37 AM
follow below steps :
> boot s72033-xxxx.bin (image shown in the bootflash)
once booted success (if not get new image put in USB follow same proceedure boot from USB)
Once it boot
> enable
# show boot
set boot variable.
config t
#boot system sup-bootflash:s72033-xxxxxx.bin
wr
reboot - connect console post complete output if you have still issue.
10-21-2020 01:09 AM
i will set up new ios first !
10-21-2020 03:23 AM
No problem keep us posted any issue.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: