cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1943
Views
6
Helpful
7
Replies

6500 ROMMON requirment for vss

esther.pywong
Level 1
Level 1

I have one 6506-E in production network with s2t54-IPSERVICESK9-M), Version 15.0(1)SY3.

ROM: System Bootstrap, Version 12.2(50r)SYS2, RELEASE SOFTWARE (fc1).

And i am going to form vss with another new 6506-E. But the System Bootstrap is not in the same version.
ROM: System Bootstrap, Version 12.2(50r)SYS3, RELEASE SOFTWARE (fc1)

So may I know if the ROMMON should be in the same version? Since I did not find any requirment about ROMMON in vss. Thanks!

1 Accepted Solution

Accepted Solutions

Esther,

Rommon version will not cause any problem for the VSS migration.

Regards

Inayath

View solution in original post

7 Replies 7

Ganesh Hariharan
VIP Alumni
VIP Alumni
I have one 6506-E in production network with s2t54-IPSERVICESK9-M), Version 15.0(1)SY3.
ROM: System Bootstrap, Version 12.2(50r)SYS2, RELEASE SOFTWARE (fc1).
And i am going to form vss with another new 6506-E. But the System Bootstrap is not in the same version.
ROM: System Bootstrap, Version 12.2(50r)SYS3, RELEASE SOFTWARE (fc1)
So may I know if the ROMMON should be in the same version? Since I did not find any requirment about ROMMON in vss. Thanks!

Hi,

Check out the below link on software /hardware pre-requsite for VSS configuration.

Pre-Requisite for VSS

Hope it Helps..

-GI

Rate if it Helps

Yes, Thanks.

But the problem is my IOS is in the same version. Only the ROMMON version is different.

And the hardware and software requirements of VSS do not talk about the ROMMON requirment.

So I am just want to make sure the different ROMMON version will not cause any problem of the VSS migration. Thanks.

Esther,

Rommon version will not cause any problem for the VSS migration.

Regards

Inayath

Thanks, InayathUlla!!

Thanks for your link!

yasir shaikh
Level 1
Level 1

hi 

Friend..

step 1

Go to romman Mode in VSS switch

step2

Clear virtual-switch         //disable vss mode///

Step3

Upload New IOS in all switches  using managment Port Through TFTP server

step4

Boot all switches using New IOS

step5

At last u configure VSS

step6

verify show version command

Thanks for the detail step for VSS.

Review Cisco Networking for a $25 gift card