01-08-2020 02:56 AM
Hello Community,
In the process of upgrade Cisco 6506-E, with the aim of moving from 151-1.SY2 to 155-1.SY4, the supervisors completed the upgrade as expected, however on completion of the upgrade the SPF line Card didn't come online fully. The SFP card itself still appeared under 'show module' but beyond that there was not much else; no active interfaces, no visibility under 'show interface', etc
Below I have included the output from 'show module', however, there seems to be a slight discrepancy on the line card itself. Below it is listed as WS-X6824-SFP, but on the physical card there is a label stating 'Factory ID: WS-X6824-SFP-2T'.
Module Output:
Mod Ports Card Type Model
--- ----- -------------------------------------- ------------------
1 24 CEF720 24 port 1000mb SFP WS-X6824-SFP
5 5 Supervisor Engine 2T 10GE w/ CTS (Acti VS-SUP2T-10G
6 5 Supervisor Engine 2T 10GE w/ CTS (Hot) VS-SUP2T-10G
Mod Sub-Module Model Hw
---- --------------------------- ------------------ ----
1 Distributed Forwarding Card WS-F6K-DFC4-A 2.0
5 Policy Feature Card 4 VS-F6K-PFC4 2.1
5 CPU Daughterboard VS-F6K-MSFC5 2.1
6 Policy Feature Card 4 VS-F6K-PFC4 2.1
6 CPU Daughterboard VS-F6K-MSFC5 2.1
The upgrade has been rolled back for now.
Any advice would be appreciated.
Cheers,
B
01-08-2020 03:48 AM
>...no active interfaces, no visibility under 'show interface', etc
Can you elaborate on these observed conditions. Meaning provide output of show interface, and oe how do you conclude no active interfaces ?
M.
01-09-2020 04:43 AM
01-08-2020 03:50 AM
01-08-2020 04:12 AM
- I confirm, you need to scrutinize the boot process for the intended version and look for error messages (e.g.) especially related to the particular module.
M.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide