Switching

Hello, After giving up on trying to get this or any C9300 (I have tried on 3) to go into configuration and trying everything posted here in the forum.   I decided to try loading the IOS  FUJI 16.9.3 firmware and performed a factory reset all accordin...

Hello,I tried the steps mentioned in the links below:http://www.cisco.com/en/US/products/hw/switches/ps663/products_password_recovery09186a00800945f7.shtmlhttp://www-tss.cisco.com/eservice/compass/common/activities/password_1700.htmhttp://www-tss.cis...

The senior IT person for our company recently passed away from, wait for it, COVID-19. I have been tasked with taking over. I am the network and hardware guy but I didn't handle any of the Cicso we have. I don't have a lot of experience with it but I...

Dear Sir, Model: SF300-24P 24-Port 10/100 PoE Managed Switch with Gigabit Uplinks: What is minimum load to be provided, to fulfill the MPS (maintain power signature of POE)? Rgds.

hello mates,I can't fully understand one point with route-maps:if we have a route map that it contains this statement:route-map fred deny 10match ip address oneand the access-list named "one" is only denying routes.So routes in ACL "one" will be perm...

Hello all,Few of our branch office switches are running with high memory utilization, we are receiving alerts on our monitoring tool for the same. Monitoring tool shows Memory 1 is running with 90% (above threshold limit) and other memory is fine. Th...

Guys, Need some input.  Does anyone know if this model SFP will work with Cisco 3850/4500X switches? HP JD092Bhttps://h20195.www2.hpe.com/v2/default.aspx?cc=id&lc=en&oid=4179912 Thanks in advance!  

has anyone ever experienced alerts on cisco SW-9200-48P like this? is this because of a bug or not? because I have checked for the bug itself in the previous IOSversion ... *note, the IOS version I'd use is 16.12.03a

I've been reading about voice vlan and have been trying to understand when to use any of the 4 different commands when setting up a switch port to hold a VOIP phone that has a PC connected to it. The 4 commands are: switchport voice vlan vlanidswitch...

Hello Cisco Community !I'm currently in school working on a project. To summarize it, I need to connect DHCP Clients on two Catalyst 2960 on a Vlan. These 2960s are connected to a 3560-E (Layer 3 Switch) by a trunk connection. This L3 is connected to...

Hello, I would like to call up the ports on a switch that have not been used for 14 weeks. I have given this command:show int | i proto.*notconnect|proto.*administratively down|Last in.* [14]w|Last in.*[0-9][0-9]w|[0-9]y|disabled|Last input never, ou...